DMT Presenter Control Guía de usuario descargar pdf (Pagina 32)

S1 User Handbook

USER GUIDE

Auxiliary Outputs

The S1 has two auxiliary buses so that alternative

outputs from the PGM can be created and used. The

mix that is created on these buses is available from

a 9 pin d-type connector which is located on the

rear panel. For more information on the use of the

auxiliary bus, please read section 3 – Making the most

of the auxiliary outputs (page 28).

Auxiliary master gain and PRE / POST

Selection

Each auxiliary bus has a master gain control. This

controls the level of the whole bus between fully

attenuated and unity. Each bus also has a global

setting of PRE or POST fader. If PRE is selected, each

channels audio is routed to the auxiliary bus before it

passed through the fader. This means that the fader

has no eect. If POST is selected, the audio is routed

to the auxiliary bus after it has passed through the

fader. This means that the fader now plays a part in

the overall level of that channel on the auxiliary bus.

This is true whether the channel is turned on or not.

If POST is selected, the button will be illuminated

red. Both buttons can be locked in either mode.

Additionally, by default, a POST auxiliary bus can

not be set to PRE until all the faders are down. For

more information on how to congure these options,

please read section 4 – SCi (page 35).

Fig 2-33: Stereo

Aux Outputs

Fig 2-34: Auxiliary master gain and PRE /

POST Selection

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 79 80

Sin comentarios

DMT Presenter Control Guía de usuario Pagina 32